Contact         Home         About        Catalog         FAQ         Duckworks Magazine
 

boat plans

canoe/kayak

electrical

epoxy/supplies

fasteners

gear

hardware

hatches/deckplates

media

paint/varnish

rope/line

rowing/sculling

sailmaking

sails

tools

 

Portable LED Navigation Lights
Red/Green Combination Bow Lights - Click here for Stern Lights

IL-560-1110 - Suction Cup Mount - $23.97
IL-560-1111 - "C" Clamp Mount - $23.97
IL-560-1112 - Flange Mount Base- $23.97

IL-560-1110 - IL-560-1111 - IL-560-1112

Since we first started carrying these wonderful LED portable navigation lights, we have sold hundreds of them with almost no complaints. What's to complain about - they work! These lights are very well constricted and robust.

Each of these lights is the same - only the mounting hardware is different. Carefully read the following descriptions to determine which is best for you.

  • IL-560-1110 - Suction cup mount. The 3" dia. cup will screw into the end or side of the light. Fine where a smooth surface exists where the light needs to mount. A safety line should be tied to the light.
  • IL-560-1111 - "C" Clamp mount. The clamp screws into either the end or side of the light. Attach this light to a gunwale, or any lip less than 2-1/2 inches thick.
  • IL-560-1112 - Flange Mount. This light comes with a hard rubbery 2-1/4" dia. flange that is designed to be glued to an inflatable dinghy, but could actually be glued or even screwed to almost any surface. It comes with a Stainless Steel spring clip so it can be removed when not in use. Like the others it will mount vertically or horizontally.
Each of these lights has two waterproof, threaded sockets that the mounting hardware will fit. One is located at the bottom of the barrel and one is on the side. If you are using a suction cup, for instance, it can either be screwed into the end or the side of the unit.

    The following applies to all three lights:

    # Requires 4 "AA" Batteries (Not Included)
    # Molded One Piece White Body Construction
    # Shock Resistant Neoprene Accents
    # Rated at 100,000 Hours LED Service Life
    # Uses 90% Less Energy than Incandescent
    # Sealed Heavy Duty On/Off Switch
    # Insert Molded Brass Threaded Mounting Bushings
    # Removable Lamp Carriage Assembly
    # Fully Buoyant

    You may also need a White Stern Light


Feedback:

Chuck,

I finally mounted the boat lights that I bought from you a while back. They worked great. I used several one inch screws to mount the front light's base to the front deck. Being able to remove the light by pulling out the cotter pin and stow it out of the way is very handy.

Cheers, Murray


Hi Chuck a while back I bought a set of Portable LED Nav lights from you, I really like them but the flange to mount them is a little flimsies. I have attached some pics on how I've mounted them on my Com Pac 16. I've cut a notch in the mounting tube to fit the screw on the shank of the light. So all I have to do is aline the screw and then the pin holes are ready all the way thru. (see the pics) - Rob Anderson