SD-400013

Injection Molded Nylon/Chrome Plated Zinc. LED Fold Down All Around Lights are approved for USCG 2NM (Colreg 2 mile). 12 Volt DC.

SD-400013 above

Note: drawings are not proportonial

SD-400015 below

Part #	A	B	C	D	Fastener
SD-400013	24"	1-7/8"	2-1/2"	na	#8FH
SD-400015	24-5/8"	18-1/2"	5/8"	2-7/8"	#8FH

Feedback:

Hi Sandra,

Attached are the photos I promised of you of the LED all-around light installed on the Escargot canal boat I am building. The light appears to be well made and was easy to install. Since the roof of my boat is rounded I had to make a fairing block to match the pitch of the roof in order to make it stand up straight. Another interesting feature of this light is that the staff appears to be the same diameter of ½" conduit, so a longer staff would be easy to fabricate if needed. I haven’t powered-up the light yet because the boat hasn’t been wired. I need to float it before wiring to see where to place the battery for best trim first.

click images above to enlarge

I also added a couple of more pictures to show the Retro Side Lights and scuppers installed that came from Duckworks.

Thanks for supply good quality boat pieces at very reasonable prices.

John C