Contact         Home         About        Catalog         FAQ         Duckworks Magazine

boat plans






gift certificates














Silvertip GelMagic Caulking Tube
6.45 oz cartridge - $20.95
- Qty
(each tube includes one mixing tip)
Extra Mixing tip - $2
- Qty

Convenient Adhesive Dispenser
Simplicity in epoxy adhesive use has finally arrived! Just drop System Three's new cartridge into a standard size caulking gun, add a mixer tip and squeeze and apply. What could be easier? Only need a little bit and don't want to use a tip? Then use the dispensing tip to squeeze out some into a cup, mix and apply. In either case the cartridge properly measures the resin and hardener and can never get the ratio wrong. After you're done put the cap back on and the cartridge is ready to go whenever you next need it.

For the technically minded who want to know how this can possibly work, here is a PDF Brochure on the cartridge itself.

Mixing tip (above) - one is included with each tube.

SilverTip GelMagic
GelMagic is a toughened, non-sagging, two component, structural epoxy adhesive designed for superior bonding to wood and most porous materials. It is unique in that it starts as two self-leveling liquids, which form a soft, thixotropic, sag-resistant paste when mixed. Measuring is easily accomplished by either volume or weight. GelMagic requires no additional modification with fillers and can be applied to vertical and overhead surfaces without running, eliminating the mess and waste associated with other epoxies. GelMagic exhibits exceptionally high peel strength and employs a state of the art, two-phase epoxy morphology, which creates an adhesive bond that is tougher, more resistant to embrittlement and has better elevated temperature properties than other room temperature cured epoxy adhesives. GelMagic can be post-cured up to 140°F for even greater performance.

Recommended Uses:
Specifically designed for optimum adhesive properties. Not a general-purpose resin made for coating and then modified with filler to act as an adhesive. When fully cured, it is unaffected by water, oil, kerosene, and many other chemicals. It will not stain wood and is immune to fungus and rot. GelMagic is ideal for stitch-and-glue, plywood, strip built and glued lap strake construction. Also use GelMagic as a high strength, gap filling, waterproof adhesive for general woodworking and architectural applications.

Mixed at a 2 to 1 by volume ratio, GelMagic will cure at temperatures as low as 35°F. Two color component system aids in determining a complete mix. Mixes to a pre-thickened, non-sagging state. No fillers needed.

Resin (part A): Blue
Hardener (part B): Amber
Mixed Color: Tan

For health and safety information concerning this product, please refer to the Material Safety Data Sheet (MSDS).




You may also need: