Hardware

These oarlocks and sockets are made of maleable iron that is heavily galvanized by the 'hot dip' method. Some say they are better than Bronze or stainless. They are certainly less expensive. Sockets are either angle mount or top mount...

These commonly seen T-handle drain plugs are similar to the ones you see in Wal-Mart, but these are Stainless Steel, not zinc plated steel. They will not rust. Any 1" hole in a transome or other location will work. You can install a section of tubing or...

Sea-Dog Line Pop-Out Deck Plates are UV stabilized and feature an integrated Pop-Up lever which makes opening and closing a snap, no tools required. Engineered rubber O-ring give a watertight fit. Patent Pending. These deck plates are easier to open and...

These are the bottom hinges that screw directly into a coaming or deck. In the picture above, you can see that the SD-273230 (left) is angled about 5-7 degrees for cambered or canted decks. The photo above shows the difference between top mount and side...

These are used at the ends of the metal hoops which hold up the fabric on a bimini. We have inserts and caps for both 3/4" and 7/8" tubing. Usually Aluminum is used, but we have found that the inserts for 3/4" tubing are almost a perfect fit in 1/2 steel...

Cast Brass butt hinges for the boats that deserve or require something better than hardware store hinges. Part# A B C D E Fastener SD-204526 1-1/2" 3/4" 3/4" 2-3/4" 1/16" #6 FH SD-204526L 1-1/2" 3/4" 3/4" 2-3/4" 1/16" #6 FH

Cast Brass butt hinges for the boats that deserve or require something better than hardware store hinges. Part# A B C D E Fastener SD-204516 1-1/2" 3/4" 3/4" 2" 1/16" #6 FH SD-204516L 1-1/2" 3/4" 3/4" 2" 1/16" #6 FH

A high quality stamped 304 Stainless Steel hinge at an economy price. Takes 5 #8 flat head fasteners.

Stamped pad eyes - strong and economical. Made from 304 stainless steel. Part # A B C D E SD-081101 7/16" 7/16" 1-1/8" .060" 5/32" SD-081102 1/2" 9/16" 1-3/8" .080" 3/16" SD-081103 3/4" 3/4" 1-3/4" ...

Easy to tension, easy to release even when wearing thick gloves. Grips the line to resist being shaken loose-even in extreme conditions. Two sizes hold a wide variety of ropes - from 0 to 5mm (0" to 3/16"). Patented toothform holds high loads without...

A deceptively simple ridged `V' groove holds ropes firmly, yet is devoid of any moving parts to break or seize. It allows the immediate release of the rope by a short upward and backward pull. Always tension the rope before it enters the cleat...

These gudgeons were developed for the Weekender Set, but will work with many of our 3/8" pintles. (see chart to figure out which will work) They are designed to be mounted vertically in cases where the boat is a double-ender or where a...